Login Register

Main Page Contact About Store Policies
CZ
Zoom
452/453/455 11mm Dovetail to Picatinny Scope Mount
Item: 19008  Back Ordered
| Manufacturer: DIP, inc
MSRP: $45.99 Your Price: $42.97
Quantity:
Produced from high quality 6061 aircraft aluminum on computer controlled milling machines right here in the US. Mil spec hard anodized for a long lasting finish. Slides onto the dovetail and easily attaches with the six(6) supplied set screws that, unlike a 4 screw system, allows you to level the rail BEFORE you install your optics. No drilling or tapping required. Accepts Picatinny and Weaver style rings.

Fits the CZ 452/453 and 455 with 11mm dovetail.

Adds approximately .220" to the receiver height


Please see the Chart Here, the CZ catalog or measure the top of your dovetail: 11mm = approx. 11mm(.43") wide


Tools needed:
1/16" Allen
Blue LocTite

Note: Fits the Kimber 82G flat top receivers, fitting required for the round receivers.
Manufacturer: DIP, inc
Shipping Weight: 0.18 lbs
Average Rating
 4.8 stars (based on 5 reviews)
You must be logged in to write a review
Recent Reviews
Rating:
Reviewed By: Paul S.
Review Date: 8/19/2012
Comments: Just put this product on my new Ultra Lux. Looked at other products, but I wanted the stability of a one-piece mount. Other one I considered was more expensive and had the side screws that would "dig in" to the built-in dovetail, not to my liking. In...
Read Full Review

Rating:
Reviewed By: TOP PREDATOR
Review Date: 5/30/2012
Comments: I’ve used the D.I.P. bases on my savage rimfires, so when thinking of adding a MOA sloped or 1 piece picatinny style base, and when compared to other similiar base manufacturer's in the same price range or less, the D.I.P. (Diversified Inovative Products ...
Read Full Review

Rating:
Reviewed By: Donald C.
Review Date: 11/26/2011
Comments: I used this rail on my 452 Trainer. Fit and finish are excellent. It slid into the 11mm groove like a glove. Six set screws and a TINY amount of loctite, 24 hour 'cure' time and it was done. It allowed me to install a Redfield 4-12 without removing the re...
Read Full Review

Rating:
Reviewed By: JEH97LX
Review Date: 3/18/2011
Comments: Product quality is good. Fits my CZ 452 trainer perfectly. Con: Screws/tap were WAY too tight to move, I probably should have called. It worked, but I broke my 1/16 hex key on the last screw.

Rating:
Reviewed By: Michael K.
Review Date: 11/18/2010
Comments: I have two of these rails, one on a CZ 452FS in 22LR, and one on a CZ Special Trainer in 17HMR. I use the rail with a Weaver-based Centra rear aperture sight on the FS, and with a Clearridge scope/Leupold QRW Quick Release rings on the Trainer. The rail...
Read Full Review
Read All Reviews



Main Page | Privacy | Contact | About | Store Policies